Lithium Battery Packs

Features of the 12V or 24V Alternator Open Circuit Protection Device:

• Protects alternator from massive spikes caused when a cable is loose or a fuse blows.
• Simple safe emergency route for that spike to be discharged giving full protection to the alternator’s regulator.Does not carry the main current so only light wiring is required
• Works with any alternator or splitting device (12V or 24V).

The 12V or 24V Alternator Open Circuit Protection Device is a highly effective alternator protection device which prevents high voltage back EMF spikes from destroying your alternator’s expensive regulator and internal diode pack. The 12V or 24V Alternator Open Circuit Protection Device prevents extreme damage occurring to your main and auxiliary system devices. Most common faults which cause this problem are:

• Loose wires causing an alternator wire to become undone/loose causing sparking.
• Failure in a split diode/relay charging system, open circuiting this system.
• Someone switching off engine’s electrical power when engine is actually running.
• Defective rotary battery selection switch causing arcing during rotation.
• Failure of a fuse if fitted in the alternator’s circuit.

All of the above events could easily destroy your alternator’s sensitive parts, this device will prevent this by diverting any high spike build up to earth. This is effective from full power to no power fault events on the alternator. Most alternator regulators and internal diode packs will be damaged by spikes in excess of 40V. The 12V or 24V Alternator Open Circuit Protection Device is designed to absorb spikes in excess of 18V (12V) and 36V (24V systems).

 

Installation:

(We do not supply any cables with the 12V or 24V Alternator Open Circuit Protection Device, we recommend the use of a 10A cable (place device as near to alternator as possible)

Simply connect the positive/negative output connection from the 12V or 24V Alternator Open Circuit Protection Device to the positive/negative output of the alternator. It’s always best to connect the device ring terminal to the inside of the bolts of the alternator’s main power cables. There will already be the main alternator outputs on the alternator’s stud. For maximum protection remove the main cables after (thus sandwiching in the protection cable). If the tensioning nut on the main cable becomes loose the main cable will fall off first leaving the protection device on the alternator, this will save the alternator. If the 12V or 24V Alternator Open Circuit Protection Device cable is on top of the live cable (not held in by the live cable) then, when the device cable falls off, the alternator will not be protected.

In the event there are no nuts then it’s up to the installer to connect the wires as close as possible to the alternator’s main power output. The closer the 12V or 24V Alternator Open Circuit Protection Device wires are fitted the more possible events it can protect for.